2-26
Basic Operation
Lexicon
Press Load/✱ again to move the asterisk to the register matrix
location.
When the asterisk is positioned in front
of the register matrix location, ADJUST
or SELECT will scroll through the
available registers.
Name: Deep Blue
R0 ✱ 0.0 available
STORE OPERATIONS (continued)
Renaming the Effect
Renaming an effect is straightforward.
With the asterisk and the cursor
positioned as shown below, turn
ADJUST to select a new character.
Press Up or Down to select a new
character type (upper case, lower
case, numeric, symbolic, or blank).
Simultaneously press Up and Down
to clear all characters from the cursor
to the end of the line. Turn SELECT to
reposition the cursor over a character, and ADJUST to change it.
Continue this until you have finished entering the new name. A
maximum of 12 characters (including spaces) may be used.
Use ADJUST to select a new character. Turn SELECT to move the
cursor to another position.
Name: ✱ D eep Blue
R 0.0 available
Selecting a Bank and Register Location
Press Load/✱ to move the asterisk to the Register Bank ID.
PCM 91 Character Set
! “ # $ % & ‘ ( ) * + , - . / 0 1 2 3
4 5 6 7 8 9 : ; < = > ? @ A B C D
E F G H I J K L M N O P Q R S T U
V W X Y Z [ ¥ ] ^ _ ‘ a b c d e f g
h i j k l m n o p q r s t u v w x y z
{ : } ~ z (space)
The @ and the $ symbols are used
to represent Custom Control values.
When the asterisk is positioned in front
of the Bank ID, ADJUST or SELECT will
scroll through available register banks.
Name: Deep Blue
✱R0 0.0 available
Once you have made all the changes you want to an effect, and
have selected a register location, press Store. If you press Store, the
display will ask "Are you sure?" (Press STORE). If you don't want to
save the effect as shown, press any button to cancel the operation.
Press Store to complete the operation.
THE FULL EDIT MATRIX
Setting Edit Mode to Pro (Control Mode 1.0) gives you access to
the full parameter matrix of the algorithm for any loaded effect
whenever you press the front panel Edit button.
To select any parameter for adjustment, use SELECT to move
horizontally across the matrix and the Up and Down buttons to
move vertically. An asterisk (✱) appearing before a displayed
parameter indicates that more than one parameter is available at
that location. Press Load/ ✱ to display these additional parameters.
Each of the five PCM 91 algorithms has a unique matrix, but many
parameters are common to all effects, and their placement within
the matrix is consistent. For example, all parameters within a given
row of any matrix are related. This type of grouping is
immediately apparent from the name of the row. For example the
"Time" row in any matrix will contain all of the available duration
controls for the effect's reverberator.
To Next Page
Loading...
