LEXIN FT4 Pro - Certification and Safety Approvals; FCC Compliance and Interference; RF Exposure Compliance

15
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
RF Exposure Information:
FCC RF Exposure requirements:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instructions
for satisfying RF exposure compliance. The antenna used for this transmitter must not
transmit simultaneously with any other antenna or transmitter, except in accordance
with FCC multi-transmitter product procedures. This product is compliance to FCC
RF Exposure requirements and refers to FCC website.
https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm
search for FCC ID: 2ARGO-LXFT4 Pro
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1)this device may not cause
interference, and(2) this device must accept any interference, including interference
that may cause undesired operation of the device
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
auxappareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :(1) l'appareil ne doit pas produire de brouillage, et(2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre lefonctionnement.
This EUT is compliance with SAR for general population/uncontrolled exposure
limits in IC RSS-102 and had been tested in accordance with the measurement
methods and procedures specified in IEEE 1528 and IEC 62209. This equipment
should be installed and operated with minimum distance of 1cm between the radiator
and your body. This device and its antenna(s)must not be co-located or operating in
conjunction with any other antenna or transmitter.
Cet appareil est conforme aux limites d'exposition DAS incontrôlée pour la
population générale de la norme CNR-102 d'Industrie Canada et a été testé en
conformité avec les méthodes de mesure et procédures spécifiées dans IEEE 1528 et
IEC 62209. Cet appareil doit être installé et utilisé avec une distance minimale de 1
cm entre i'émetteur et votre corps. Cet appareil et sa ou ses antennes ne doivent pas
être co-localisés ou fonctionner en conjonction avec tout autre antenne ou
transmetteur.