10
IPDS Printer and Host Setup Guide iSeries and AS/400 LAN Printing Using the Printer Standard Network Port or MarkNet Internal Print Server
Note 1: Setting the Activation Timer to *NOMAX allows multiple writers or multiple hosts to use
the same printer. The writer does not time out while waiting on the printer to start a new job.
Step 4 Configure the Printer’s Print Server TCP/IP Settings
To enable IPDS printing with a Standard Network port or a MarkNet internal LAN print server, several settings
must be verified. You can verify these settings from the printer control panel as shown below.
1 From a Ready state press the MENU button (printers). Touch or on touch screens.
2 Use the navigation buttons or icon to scroll to Network/Ports.
3 Select Network/Ports.
TIp: To do this on printers, press the Select button ; on touch screens touch Network/Ports.
4 Now you will see a list of menus. Select the Standard Network menu.
5 Select Std Network Setup.
6 Select TCP/IP.
7 Use the navigation buttons or icons to scroll through the options. Check each of the following settings and
change them as needed to configure TCP/IP communication.
Remote network identifier............. RMTNETID *NETATR
Workstation customizing object........ WSCST *NONE
Library............................
Authority............................. AUT *LIBCRTAUT
TCP/IP Settings
Parameter Value
Activate On
(Printers: Must be "On" to enable TCP/IP communi-
cations. MFPs: not displayed.)
IP Address 157.184.67.102
(Address available from your network administrator)
Netmask 255.255.255.0
(Appropriate netmask for your network)
Gateway 157.184.67.1
(IP address of your IP gateway)
Enable DHCP On or Off
(On, if you use a DHCP server.)
(Off, if you set the IP address another way.)
Example CRTDEVPRT with parameters to change shown in
bold.
To Next Page
Loading...
Need help?
General