PJL
3-49
Printer Unique Variables for PCL Emulation
The following variables are unique to your printer and are supported in PCL emulation
only. The
[command modifier:value] parameter should be specified as LPARM:PCL.
For example:
@PJL SET LPARM:PCL LBITMAPROUNDING=OFF[<CR>]<LF>
To determine which variables your printer supports, see “Table B-4: Printer Unique
Variables for PCL Emulation” on page B-12.
Table 3-6: Printer Unique Variables for PCL Emulation
Variable Function Selections Factory Default
LA4WIDTH A4 Width in
millimeters
198, 203 198
LASSIGNFEEDER Tray Renumber
Assign Envelope
Feeder
OFF, 0 to 199
Variable used with PJL SET or DEFAULT
command.
OFF
OFF, 0 to 199, NONE
Variable used with PJL INQUIRE or DINQUIRE
command.
OFF
LASSIGNMANUALENVELOPE Tray Renumber
Assign Manual
Envelope
OFF, 0 to 199
Variable used with PJL SET or DEFAULT
command.
OFF
OFF, 0 to 199, NONE
Variable used with PJL INQUIRE or DINQUIRE
command.
OFF
LASSIGNMANUALPAPER Tray Renumber
Assign Manual Paper
OFF, 0 to 199
Variable used with PJL SET or DEFAULT
command.
OFF
OFF, 0 to 199, NONE
Variable used with PJL INQUIRE or DINQUIRE
command.
OFF
LASSIGNMPFEEDER Tray Renumber
Assign Multipurpose
Feeder
OFF, 0 to 199
Variable used with PJL SET or DEFAULT
command.
OFF
OFF, 0 to 199, NONE
Variable used with PJL INQUIRE or DINQUIRE
command.
OFF
To Next Page
Loading...
