PCL
2-54
Table 2-24: Status Readback
Command / Parameters Function / Result
ESC
*s#T
0 Invalid location (Default)
1 Use currently selected location
2 All locations
3 Internal (resident)
4 Downloaded entity
5Cartridge
7 User-installable flash
200 Disk
Set Status Readback Location Type
Sets the status location type to the specified value.
The 5 value for Cartridge may be specified, but since your printer
does not support font cards or cartridges, the command is ignored.
The 7 value for User-installable flash is only valid when flash
memory is installed.
The 200 value is only valid when a hard disk is installed.
ESC
*s#U
0All
1 If download, temporary; otherwise,
highest priority
2 If download, permanent; otherwise,
next higher priority
Set Status Readback Location Unit
Sets the status location unit to the specified value.
The location unit is used along with the location type to identify a
location for the Inquire Status Readback Entity command.
Note: The unit value is interpreted differently, depending on the
location type specified.
ESC
*s#I
0Font
1Macro
2 User-defined pattern
3 Symbol set (for unbound scalable
fonts)
4 Font extended
Inquire Status Readback Entity
Returns the requested information set by Set Status Readback
Location Type and Set Status Readback Location Unit.
ESC
*s1M Free Space
Returns the total available memory and the largest available block
of memory.
ESC
&r#F
0 Flush all complete pages
1 Flush all pages
Flush All Pages
Holds print jobs in the print buffer until the current job finishes
printing.
ESC
*s#X
-32767 to 32767
Default = 0
Echo
Returns # back to host computer.
To Next Page
Loading...
