PJL
3-11
INITIALIZE Command
This command restores both the current and default environment variables to their
factory default values and updates the printer NVRAM. This command affects all of
the variables listed in “Table 3-3: Common Variables for Both Printer Languages” on
page 3-12 through “Table 3-8: Printer Unique Variables for PostScript Emulation” on
page 3-52, except the following:
• All read only variables
• PASSWORD
• LANG
• LRESOURCESAVE
• LDOWNLOADTARGET
• LPPDS
• LHONORINIT
• LUSDEFAULTS
• PARALLEL
• RESOURCESAVE
Note: This command does not affect LRESOURCE variables listed in
“Table 3-9: Printer Unique LRESOURCE Variables” on page 3-53.
Syntax:
@PJL INITIALIZE[<CR>]<LF>
RESET Command
This command resets the current environment variables to the settings stored in the
printer NVRAM. Therefore, any variables modified by the PJL SET command are
returned to their default value after execution of the PJL RESET command.
Syntax:
@PJL RESET[<CR>]<LF>
To Next Page
Loading...
Need help?
General
