Property Description Default
basic.numScheduledMfpsToRemove The number of printers to remove at the interval specified by
basic.removeMfpCronExp
1
Advanced (e‑Task 2) scheduled task properties
Property Description Default
advanced.pauseCronExp A CRON expression that schedules a pause in the test None
advanced.unpauseCronExp A CRON expression that schedules the test to resume after a pause has
been scheduled
None
advanced.addMfpCronExp A CRON expression that determines the interval at which a new printer
is added to the test
None
advanced.removeMfpCronExp A CRON expression that determines the interval at which a printer is
removed from the test
None
advanced.numScheduledMfpsToAdd The number of printers to add at the interval specified by
advanced.addMfpCronExp
1
advanced.numScheduledMfpsToRemove The number of printers to remove at the interval specified by
advanced.removeMfpCronExp
1
Supplying answers to prompts
You can supply a comma‑delimited list of answers to supply for prompts asked by the profile in the setting
basic.promptAnswers (for e‑Task printers) or advanced.promptAnswers (for e‑Task 2 printers). If the
setting is left blank, then the default response is used for all prompts. The delimiter for the list may be changed using
the delimiter setting.
If you need to supply an answer for any prompt, then you must supply all answers for the applicable logic path. To
specify the default answer for a prompt in the path, use [DEFAULT], or the answer otherwise specified by the
defaultAnswer setting. The logic path may be different depending on prompt answers, so you must plan answers
for the specific path you want to take through the prompts. It may be helpful to test the path by first using the interactive
MFP emulator.
Testing and deploying workflow solutions 61
To Next Page
Loading...
