Paper jam in the fuser
1 Open door A by lifting the release latch and lowering the door.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
2 Pull the green lever down.
2
1
3 Firmly grasp the jammed paper on each side, and then gently pull it out.
Warning—Potential Damage: Do not touch the center of the fuser unit. Doing so will damage the fuser.
Note: Make sure all paper fragments are removed.
4 Push the green lever back into place.
5 Close door A.
6 If necessary, touch Continue from the printer control panel.
Clearing jams 197
To Next Page
Loading...
