Lexmark CX310n - Page 230

• “ADF input tray removal” on page 233
• “ADF separator roll removal” on page 234
• “ADF separator pad removal” on page 234
• “AIO toner cover removal” on page 235
• “AIO link removal” on page 236
• “AIO release lever removal” on page 237
• “Bin‑full flag removal” on page 238
• “Controller board removal” on page 239
• “Developer unit removal” on page 240
• “Duplex reference edge removal” on page 241
• “Duplex sensor removal” on page 244
• “EP drive assembly removal” on page 245
• “Flatbed pivot link removal” on page 251
• “Flatbed scanner assembly removal” on page 252
• “Front logo cover removal” on page 257
• “Fuser assembly removal” on page 257
• “Fuser drive motor assembly removal” on page 259
• “Fuser exit sensor removal” on page 260
• “High‑voltage power supply (HVPS) removal” on page 262
• “Imaging unit (IU) removal” on page 266
• “Low‑voltage power supply (LVPS) assembly removal” on page 268
• “Lower left frame removal” on page 270
• “Lower right frame removal” on page 276
• “Narrow media sensor removal” on page 280
• “Narrow media sensor flag removal” on page 281
• “Operator panel bezel removal” on page 282
• “Operator panel logo plate removal” on page 282
• “Operator panel removal (for CX310 and CX410 models only)” on page 283
• “Operator panel removal (for CX510 models only)” on page 289
• “Paper pick motor drive assembly (standard tray) removal” on page 290
• “Printhead removal” on page 292
• “Redrive unit removal” on page 293
• “Speaker removal” on page 294
• “System fan removal” on page 294
• “Toner cartridge contacts removal” on page 294
• “Toner density sensor (TDS) (left or right sensor) removal” on page 296
• “Toner meter cycle (TMC) card removal” on page 298
• “Transfer module removal” on page 300
• “Tray present sensor removal” on page 302
• “USB port connector removal” on page 303
7527
Repair information
230