Replace jammed originals if restarting job.
From the printer control panel, try one or more of the following:
• Select Scan from automatic feeder, and then press to continue scanning from the ADF immediately
after the last successful scan job.
• Select Scan from flatbed, and then press to continue scanning from the scanner glass immediately
after the last successful scan job.
• Select Finish job without further scanning, and then press to end the last successful scan job.
Note: This does not cancel the scan job. All successfully scanned pages will be processed further
for copying or e-mailing.
• Select Restart Job, and then press to restart the scan job with the same settings from the previous
scan job.
• Select Cancel Job, and then press to clear the message and cancel the scan job.
Replace maintenance kit [80.xy]
The printer is scheduled for maintenance. For more information, go to http://support.lexmark.com or
contact your service representative, and then report the message.
Replace missing [color] cartridge [31.xy]
Install the indicated toner cartridge to clear the message. For more information, see the “Replacing supplies”
section of the User’s Guide.
Replace missing [type] imaging kit [31.xy]
Note: The type can be a black imaging kit, or a black and color imaging kit.
Install the indicated imaging kit to clear the message. For more information, see the “Replacing supplies”
section of the User’s Guide.
Replace missing waste toner bottle [31.xyz]
Install the missing waste toner bottle to clear the message. For more information, see the instruction sheet
that came with the supply.
Replace unsupported [color] cartridge [32.xy]
Remove the toner cartridge, and then install a supported one to clear the message and continue printing.
For more information, see the instruction sheet that came with the supply.
The following error codes indicate that a non‑genuine Lexmark toner cartridge is installed:
32.13
32.16
32.19
Troubleshooting 255
To Next Page
Loading...
