Lexmark CX725 - Modem Removal

TPS cables removal
1 Remove the controller board shield. See “Controller board shield removal” on page 408.
2 Remove the inner controller board shield. See “Inner controller board shield removal” on page 409.
3 Remove the controller board. See “Controller board removal” on page 409.
4 Disconnect the three cables (A) from the sensor.
Warning—Potential Damage: Be careful when disconnecting the cables. Press the tab on the white cable
while disconnecting to avoid damage.
5 Remove the cables.
Modem removal
1 Remove the controller board shield. See “Controller board shield removal” on page 408.
2 Disconnect the modem cable (A) from the controller board, and then remove the three screws (B).
B
A
3 Remove the modem.
7528
Repair information
411