Lexmark CX730 - Page 34

Printer model Analog fax
etherFAX
2
Fax server
3
Fax over IP (FoIP)
4
XC4342
1
XC4352
1
Needs an installed fax card to use analog fax.
2
Needs a subscription. For more information, go to https://www.etherfax.net/lexmark or contact the place where
you purchased the printer.
3
Needs a subscription for the fax server to work.
4
Needs an installed license bundle. For more information, contact the place where you purchased the printer.
Setting up the fax function using analog fax
Notes:
• For some printer models, a fax card must be installed for the printer to use analog fax.
• Some connection methods are applicable only in some countries or regions.
• If the fax function is enabled and not fully set up, then the indicator light may blink red.
• If you do not have a TCP/IP environment, then use the control panel to set up fax.
Warning—Potential Damage: To avoid loss of data or printer malfunction, do not touch cables or the printer
in the area shown while actively sending or receiving a fax.
Using the Settings menu in the printer
1
From the home screen, touch Settings > Fax > Fax Setup > General Fax Settings.
2 Configure the settings.
Using the Embedded Web Server
1
Open a web browser, and then type the printer IP address in the address field.
Set up, install, and configure 34