Lexmark CX730 - Page 35

Notes:
• View the printer IP address on the home screen. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the web page correctly.
2 Click Settings > Fax > Fax Setup > General Fax Settings.
3
Configure
the settings.
4 Apply the changes.
Setting up the fax function using etherFAX
Notes:
• The printer firmware must be updated to the latest version. For more information, see “Updating
firmware” on page 56.
• An appropriate license bundle must be installed in your printer. For more information, contact etherFAX.
• Make sure that you have registered your printer to the etherFAX portal. For more information, go to
https://www.etherfax.net/lexmark.
• The printer serial number is required on registration. To locate the serial number, see “Finding the printer
serial number” on page 10.
1 Open a web browser, and then type the printer IP address in the address field.
Notes:
• View the printer IP address on the home screen. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the web page correctly.
2 Click Settings > Fax > Fax Setup > General Fax Settings.
Note: Fax Setup appears only if Fax Mode is set to Fax.
3 In the Fax Name field, type a unique name.
4 In the Fax Number field, enter the fax number that etherFAX provided.
5 From the Fax Transport menu, select etherFAX.
Notes:
• This menu shows up only when more than one fax transport is available.
• If the printer only has etherFAX installed, then it is automatically configured.
6 Apply the changes.
Set up, install, and configure 35