Specify a unit of measurement
1 Make sure the printer is on and Ready appears.
2 From the printer control panel, press .
Paper Menu appears.
3 Press .
4 Press the down arrow button until Universal Setup appears, and then press .
5 Press the down arrow button until Units of Measure appears, and then press .
6 Press the down arrow button until appears next to the correct unit of measure, and then press .
Submitting selection appears, followed by the Universal Setup menu.
Specify the paper height and width
Defining a specific height and width measurement for the Universal paper size (in the portrait orientation) allows the printer
to support the size, including support for standard features such as duplex printing and printing multiple pages on one sheet.
Note: Select Portrait Height to adjust the paper height setting or Paper Width to adjust the paper width setting, or
adjust both. Instructions to adjust both follow.
1 From the Universal Setup menu, press the down arrow button until Portrait Width appears, and then press .
2 Press the left arrow button to decrease the setting or the right arrow button to increase the setting, and then press .
Submitting selection appears, followed by the Universal Setup menu.
3 From the Universal Setup menu, press the down arrow button until Portrait Height appears, and then press .
4 Press the left arrow button to decrease the setting or the right arrow button to increase the setting, and then press .
Submitting selection appears, followed by the Universal Setup menu.
5 Press and release until Ready appears.
Specify a feed direction
Short Edge is the factory default setting for feed direction for Universal paper settings. The Feed Direction menu will not appear
from the Universal Setup menu unless Long Edge is an available setting. If necessary, specify whether the short or long edge
of the paper will enter the printer first.
1 From the Universal Setup menu, press the down arrow button until Feed Direction appears, and then press .
2 Press the down arrow button until Short Edge or Long Edge appears, and then press .
Storing paper
Use these paper storage guidelines to help avoid jams and uneven print quality:
• For best results, store paper where the temperature is 21°C (70°F) and the relative humidity is 40%. Most label manufacturers
recommend printing in a temperature range of 18 to 24°C (65 to 75°F) with relative humidity between 40 and 60%.
• Store paper in cartons when possible, on a pallet or shelf, rather than on the floor.
• Store individual packages on a flat surface.
• Do not store anything on top of individual paper packages.
Media guide
Page 4 of 4
To Previous Page
Loading...
Need help?
General
Weight and Dimensions
