I931:F%7B1'#!-6
Menu item Description
I%7-1'I:'(%%9%
On
Off
Prints a page containing the PostScript error
Note: Off is the factory default setting.
R9-1'I%79%71<
Resident
Flash
Establishes the font search order
Notes:
• Resident is the factory default setting.
• A formatted optional flash memory card must be installed in the printer
and operating properly for this menu item to be available.
• The optional flash memory card cannot be Read/Write, Write, or password
protected.
• Job Buffer Size must not be set to 100%.
I8 '(#6E'#!-6
Menu item Description
R9-1':96%F!
Resident
Download
Flash
All
Specifies the set of fonts available
Notes:
• Resident is the factory default setting. It shows the factory default set of
fonts downloaded into RAM.
• Download appears only if downloaded fonts exist. It shows all the fonts
downloaded into RAM.
• Flash appears only if an optional flash memory card containing fonts is
installed.
• An optional flash memory card must be properly formatted and cannot be
Read/Write, Write, or password protected.
• All shows all fonts available to any option.
R9-1'O$#!
<list of fonts>
Lets you view or change the setting from a selection list
:<#@9E':!1
<list of symbol sets>
Lets you view or change the setting from a selection list
I8 '(#6E$179-':!117-?3
Point Size
1.00–1008.00
Changes the point size for scalable typographic fonts
Notes:
• 12 is the factory default setting.
• Point Size refers to the height of the characters in the font. One point equals
approximately 1/72 of an inch.
• Point sizes can be increased or decreased in 0.25-point increments.
:"5$,%#("5+"/&3,+"#$,&-$"1%
CCC
To Next Page
Loading...
