DFF!337-?'1A!'3<31!#'@9$%,'19'7-31$EE'7-1!%-$E'9B179-3
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have other devices attached to the printer, then turn them off as well, and
unplug any cables going into the printer.
1 As you face the printer, the system board door is on the right side. Open the system board door.
2 Use the following illustration to locate the appropriate connector.
Warning—Potential Damage: System board electronic components are easily damaged by static electricity.
Touch something metal on the printer before touching any system board electronic components or connectors.
1
Ethernet connector
Note: The Ethernet port is a feature on network models only.
2
USB port
3
Parallel connector
4
Memory card connector
5
Optional card connector
6
Optional card connector
455+#+!"(6&3,+"#$,&%$#13
0C
To Next Page
Loading...
