Menu item Description
I9%1%$71'V7,1A
3–14.17 inches
76–360 mm
Sets the portrait width
Notes:
• If the width exceeds the maximum, then the printer uses the
maximum width allowed.
• 8.5 inches is the US factory default setting. Inches can be increased
in 0.01-inch increments.
• 216 mm is the international factory default setting. Millimeters can
be increased in 1-mm increments.
I9%1%$71'S!7?A1
3–14.17 inches
76–360 mm
Sets the portrait height
Notes:
• If the height exceeds the maximum, then the printer uses the
maximum height allowed.
• 14 inches is the US factory default setting. Inches can be increased in
0.01-inch increments.
• 356 mm is the international factory default setting. Millimeters can
be increased in 1-mm increments.
R!!,'a7%!F179-
Short Edge
Long Edge
Specifies the feed direction
Notes:
• Short Edge is the factory default setting.
• Long Edge appears only if the longest edge is shorter than the
maximum length supported in the tray.
c!B9%13'#!-6
c!B9%13'#!-6
To print a report, use the arrow buttons to navigate to the type of report you want, and then press
.
Menu item Description
L!-6':!117-?3'I$?!
Prints a report containing information about paper loaded into trays, installed
memory, the total page count, alarms, timeouts, the printer control panel
language, the TCP/IP address, the status of supplies, the status of the network
connection, and other information
a!M7F!':1$17317F3
Prints a report containing printer statistics such as supply information and
details about printed pages
O!1/9%&':!16B'I$?!
Prints a report containing information about the network printer settings, such
as the TCP/IP address information
Note: This menu item appears only for network printers or printers connected
to print servers.
:"5$,%#("5+"/&3,+"#$,&-$"1%
QH
To Next Page
Loading...
