Lexmark MC3426i - Configuring the E-Mail SMTP Settings

Setting the fax date and time
Note: Make sure that fax is
configured.
For more information, see “Setting up the printer to fax” on page 24.
1 From the home screen, touch Settings > Device > Preferences > Date and Time > Configure.
2 Configure the settings.
Configuring daylight saving time
Note: Make sure that fax is
configured.
For more information, see “Setting up the printer to fax” on page 24.
1 From the home screen, touch Settings > Device > Preferences > Date and Time > Configure.
2 In the Time Zone menu, select (UTC+user) Custom.
3 Configure the settings.
Configuring
the fax speaker settings
Note: Make sure that fax is configured. For more information, see “Setting up the printer to fax” on page 24.
1 From the home screen, touch Settings > Fax > Fax Setup > Speaker Settings.
2 Do the following:
• Set Speaker Mode to Always On.
• Set Speaker Volume to High.
• Enable Ringer Volume.
Configuring the e‑mail SMTP settings
Configure the Simple Mail Transfer Protocol (SMTP) settings to send a scanned document through e-mail. The
settings vary with each e‑mail service provider. For more information, see
e‑mail service providers.
Before you begin, make sure that the printer is connected to a network and that the network is connected to
the Internet.
Using the e‑mail setup wizard in the printer
Note: Before using the wizard, make sure that the printer firmware is updated. For more information, see
“Updating firmware” on page 46.
1 From the home screen, touch E‑mail.
2 To uch Set up now, and then type your e‑mail address.
3 Type the password.
Notes:
• Depending on your e-mail service provider, type your account password, app password, or
authentication password. For more information on the password, see the list of
e‑mail service
providers, and then look for Device Password.
Set up, install, and configure 32