Selecting a location for the printer
When selecting a location for the printer, leave enough room to open trays, covers, and doors. If you plan to
install any options, then leave enough room for them also. It is important to:
• Set up the printer near a properly grounded and easily accessible electrical outlet.
• Make sure airflow in the room meets the latest revision of the ASHRAE 62 standard or the CEN Technical
Committee 156 standard.
• Provide a flat, sturdy, and stable surface.
• Keep the printer:
– Clean, dry, and free of dust.
– Away from stray staples and paper clips.
– Away from the direct airflow of air conditioners, heaters, or ventilators.
– Free from direct sunlight and humidity extremes.
• Observe the recommended temperatures and avoid
fluctuations.
Ambient temperature 15.6 to 32.2°C (60 to 90°F)
Storage temperature 1 to 35°C (34 to 95°F)
5
1
2
3
4
1
1 Right side 110 mm (4.33 in.)
2 Front 305 mm (12 in.)
3 Left side 65 mm (2.56 in.)
4 Rear 100 mm (3.94 in.)
5 Top 305 mm ( 12 i n.)
Selecting a location for the printer 10
To Next Page
Loading...
Need help?
General
