Lexmark MS610 Series - Installing Hardware Options; Installing Optional Trays

Installing hardware options
Installing optional trays
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer
o,
and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them o as well, and unplug any cables going into the printer.
1 Turn o the printer using the power switch, and then unplug the power cord from the electrical outlet.
2
1
2 Unpack the tray, and then remove all packing materials.
3 Pull the tray completely out of the base.
2
4 Remove any packing material from inside the tray.
5 Insert the tray into the base.
6 Place the tray near the printer.
7 Align the printer with the tray, and then lower the printer into place.
Note: Optional trays lock together when stacked.
Additional printer setup 27