Doc No.:     Rev. 001     Page 1 of 17 
       
 
 
 
Disassembly of Waste Electrical and Electronic Equipment (WEEE) Manual 
 
 
EU Waste Electronic and Electrical Equipment Directive require producers to provide information of the different electronic 
and electrical materials and components found in their products at its end-of-life, and disassembly references to treatment 
and recycling facilities. 
 
The disassembly information for this product has been prepared for use by a recognized treatment or recycling facility and 
is not intended to be used by others. 
 
1.  Product information 
2.  Materials and components list for selective treatment 
3.  Disassembly tools 
4.  Disassembly references 
 
The following information is intended only for the use of treatment and recycling facilities.  
 
All disassembly instructions should be performed with the power switch in the OFF position. Disconnect the power cord 
from the wall outlet and from the printer before continuing.  If there are any other devices attached to the printer, then turn 
them off as well, and unplug any cables going into the printer. 
 
 
1.  Product information 
 
Model name(s)—Indicate all model name(s) within the product family 
 
Lexmark MS810 series – 
Lexmark MS810n, Lexmark MS810dn, Lexmark MS810dtn, Lexmark MS810de (Lexmark M5155, Lexmark 
M5163), Lexmark MS811n, Lexmark MS811dn, Lexmark MS811dtn, Lexmark MS812dn, Lexmark MS812dtn, 
Lexmark MS812de (Lexmark M5170) 
 
* Add rows as needed 
 
2.  Materials and components list for selective treatment 
 
Polychlorinated biphenyls (PCB) containing capacitors 
Mercury containing components, such as switches or 
backlighting lamps 
Lithium Manganese Dioxide coin cell 
located on the system controller card 
Printed circuit boards greater than 10 cm
2 
 
Plus one (1) for MS810dtn, MS811dtn, 
MS812dtn models (locations illustrated 
in 4.2) 
Toner cartridges, liquid and pasty, as well as colour 
toner 
Located inside front cover