Lexmark MX824 - Creating a Cloud Connector Profile; Setting up Device Quotas

Notes:
• When creating a network destination, make sure to validate and adjust the settings until no errors
occur.
• Only destinations created from the Embedded Web Server are saved. For more information, see the
documentation that came with the solution.
3 Apply the changes.
Creating a Cloud Connector profile
We recommend logging in to the printer before you create a
profile.
To enable a login method, see the
Embedded Web Server
‑ Security Admin Guide.
1 From the home screen, touch Cloud Connector.
2 Select a cloud service provider.
3 Tou ch Create a Profile or .
4 Type a unique profile name.
5 If necessary, enter a PIN.
Note: When using the printer as guest, protect the
profile
with a PIN.
6 Tou ch Create, and then take note of the authorization code.
Note: The authorization code is valid only for 24 hours.
7 Open a web browser, and then go to https://lexmark.cloud-connect.co.
8 Click Next, and then accept the Terms of Use.
9 Enter the authorization code, and then click Connect.
10 Log in to your cloud service provider account.
11 Grant permissions.
Note: To complete the authorization process, open the profile within 72 hours.
Setting up Device Quotas
You may need administrative rights to access the application.
1 Open a Web browser, and then type the printer IP address in the address field.
Notes:
• View the printer IP address on the printer home screen. The IP address appears as four sets of
numbers separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2 Click Apps > Device Quotas > Configure.
3 From the User Accounts section, add or edit a user, and then set the user quota.
4 Apply the changes.
Setting up and using the home screen applications 21