vii
4049-XXX
Removal Procedures (continued)
LVPSRemoval................................ 4-29
LVPSCoverRemoval .......................... 4-30
Operator Panel Removal ........................ 4-31
Paper Feed Rollers Removal ..................... 4-31
Paper Feed Magnet Assembly Removal ............ 4-32
Paper Size Switch Removal...................... 4-33
Printhead Removal............................. 4-34
RIPBoardandInnerEMCShieldRemoval.......... 4-35
TonerSensorRemoval ......................... 4-35
Torquer Motor Removal ......................... 4-35
TransferRollRemoval.......................... 4-36
TransferRollHousingRemoval................... 4-37
Upper Frame Removal. ......................... 4-38
Duplex Option Top Cover And Table Cover Removal . . 4-39
DuplexOptionExitCardAndCoverRemoval........ 4-40
Duplex Option Bottom Cover
AndEntrySensorCardRemoval.................. 4-41
DuplexOptionSystemCardAndMotorRemoval..... 4-42
Dual Rear Feeder - Edge Guide Asm. .............. 4-43
Dual Rear Feeder - Gear Plate Asm. ............... 4-43
Dual Rear Feeder - Right Cover. . . ................ 4-43
200-Sheet Second Drawer, Rt .................... 4-44
High Capacity Feeder Paper Feed Rollers........... 4-45
High Capacity Feeder Cover ..................... 4-47
ConnectorLocations ..................................5-1
MajorAssemblyLocations........................... 5-1
GearTrain .................................... 5-2
HVPS........................................ 5-3
TransferRollerHousing.......................... 5-3
Engine Board Connectors ........................ 5-4
RIPBoard..................................... 5-6
BoardInstallationHardware....................... 5-7
MirrorMotor/FanCable .......................... 5-7
Operator Panel/Output Bin Sensor Cable ............ 5-8
Printhead Connector Locations . . . ................ 5-10
t Cable....................... 5-10
ps . ......................... 5-11
er Board Connectors............ 5-12
To Next Page
Loading...
Need help?
General
