Problem Solution
Print on heavy stock is
blurred or out of focus.
Make sure the Paper Type setting is correct for your print material.
Note: Card stock in excess of 203 g/m
2
(54‑lb bond) may not produce acceptable print
results.
Print on five sheets of paper, wait for approximately five seconds, and then print five more
sheets of paper to remove any toner that may have accumulated.
Toner rubs off the page. Make sure the Paper Type setting is correct for your print material.
Use material that is lighter than 300 g/m
2
.
Print on five sheets of paper, wait for approximately five seconds, and then print five more
sheets of paper to remove any toner that may have accumulated.
Printing shows voids. Change the Paper Type to Plain Paper.
Print on five sheets of paper, wait for approximately five seconds, and then print five more
sheets of paper to remove any toner that may have accumulated.
General information 15
To Next Page
Loading...
Need help?
General
