For the following printers, make sure perforations fall outside the 0.12–0.91‑inch area on the leading edge of the media:
MS710, MS711, MS810, MS811, MS812, MX710, MX711, MX810, MX811, and MX812.
Pick Roller Location
0.12 in.
0.91 in.
0.56 in.
1.08 in.
2.76 in.
3.28 in.
Direction of Feed
Maintenance procedures
Note: These procedures apply only to mono laser printers.
If print quality begins to degrade when printing on vinyl labels, then do the following:
1 Print on five sheets of paper.
2 Wait approximately five seconds.
3 Print on five more sheets of paper.
To maintain printer feeding reliability, repeat this cleaning process every time you replace the toner cartridge.
Note: Failure to follow maintenance procedures for your printer could cause jams, poor print quality, feeding
problems, and fuser problems.
Troubleshooting
The following table provides solutions to some common card stock and label problems. For more troubleshooting
information, see your printer documentation.
General information 14
To Next Page
Loading...
Need help?
General
