Using the printer locally (USB)
Select the connection type that describes how you currently access your printer:
If the printer is currently set up for Ethernet
1 Attach one end of a USB cable to the USB port on the back of the printer. Attach the other end to a USB port on
the computer.
2 Close any “New Hardware Found” screens that appear.
3 Select the USB printer (see “Selecting the printer” on page 53).
If the printer is currently set up for wireless
1 Do one of the following:
• In Windows Vista, click .
• In Windows XP and earlier, click Start.
2 Click All Programs or Programs, and then select the printer program folder from the list.
3 Click Tools Lexmark Wireless Setup Utility.
4 Follow the on-screen instructions, attaching the USB cable when prompted to do so.
5 Close any “New Hardware Found” screens.
6 When prompted to choose a wireless network, select Choose Another Network.
7 Select Don't use wireless.
8 Follow the on-screen instructions to complete the setup.
Using the printer over an Ethernet network
Select the connection type that describes how you currently access your printer:
If the printer is currently set up for wireless
1 Plug one end of an Ethernet cable into the printer and the other end into an available port on a switch or wall
jack.
2 Wait for a minute for the Ethernet network interface to become active and acquire an IP address from the network.
3 Select the Network printer (see “Selecting the printer” on page 53).
Note: The wireless interface of the printer is disabled while it is connected to an Ethernet network.
If the printer is currently set up locally (using USB connection)
1 Plug one end of an Ethernet cable into the printer and the other end into an available port on a switch or wall
jack.
2 Insert the software and installation CD into the computer you want to use to configure the printer.
Installing the printer on a wireless network (selected models only)
52
To Next Page
Loading...
