Lexmark XC4342 - Page 270

Error codes Error message Solution
71.01 Fax Station Name not set
up. Contact system
administrator.
For more information, see
“Setting up
the fax function using analog fax” on
page 34.
71.02 Fax Station Number not set
up. Contact system
administrator.
71.03 No analog phone line
connected to modem, fax is
disabled.
Check the connection and the line for
a signal. For more information, see
“Setting up fax using a standard
telephone line” on page 36.
71.06 Unable to connect to HTTPS
Fax Server.
Connection to HTTPS Fax Server is
disconnected. Check the Internet
connection of the printer.
71.12 Memory full, cannot print
faxes.
Tou ch Print All to print as many of the
faxes as have been saved.
71.13 Memory full. Cannot send
faxes.
Try one or more of the following:
• Continue and try sending the fax
again.
• Scan the original document one
page at a time, dial the fax
number, and then scan the
document.
72.01 E-mail SMTP server not set
up. Contact system
administrator.
Try either of the following:
• Set up your email function. For
more information, see
“Configuring the e‑mail SMTP
settings” on page 40.
• Disable the error message. For
more information, see
“Disabling
the 'SMTP server not set up' error
message” on page 324.
80.01, 80.09 Maintenance kit nearly low. Tou ch Continue to clear the
message.
80.11, 80.19 Maintenance kit low. Tou ch Continue to clear the
message.
80.21, 80.29 Maintenance kit very low. Tou ch Continue to clear the
message.
80.31 Replace maintenance kit,
recommended life exceeded.
For more information, see
“Ordering
a fuser maintenance kit” on
page 209.
82.00, 82.02, 82.09 Waste toner bottle nearly
full.
Tou ch Continue to clear the
message.
82.12, 82.13, 82.19, 82.20, 82.22,
82.23, 82.29
Waste toner bottle almost
full.
Tou ch Continue to clear the
message.
Troubleshoot a problem 270