Lexus LS460 2011 - Page 74

72
1-2. Opening, closing and locking the doors and trunk
LS460_EE
 Setting and canceling the functions
To switch between setting and canceling, follow the procedure
below.
Close all the doors and switch the “ENGINE START
STOP” switch to IGNITION ON mode. (Perform the step 2
within 10 seconds.)
Shift the shift lever to “P” or
“N”, press and hold the driver's
door lock switch
( or ) for about 5 sec-
onds then release.
The shift lever and switch posi-
tions corresponding to the
desired function to be set are
shown as follows.
Use the same procedure to can-
cel the function.
When the setting or canceling operation is complete, all doors are
locked and then unlocked.
STEP 1
STEP 2
Function
Shift lever posi-
tion
Driver’s door
lock switch posi-
tion
Shift position linked door lock-
ing function
P
Shift position linked door
unlocking function
Speed linked door locking func-
tion
N
Driver's door linked door unlock-
ing function