1-3. Adjustable components (seats, mirrors, steering wheel)
Your preferred driving position (the position of the driver's seat and
steering wheel, angle of the outside rear view mirrors, and height of
seat belt shoulder anchor) can be memorized and recalled with the
touch of a button. It is also possible to set this function to activate
automatically when the doors are unlocked.
Three different driving positions can be entered into memory.
The same buttons are found on the front passenger’s side, allowing the
front passenger’s seat position and seat belt shoulder anchor height to
be memorized.
Entering a position to memory
Check that the shift lever is in “P”.
Turn the “ENGINE START STOP” switch to IGNITION
ON mode.
Adjust the driver’s seat, steering wheel, outside rear view
mirrors and seat belt shoulder anchor height to the
desired positions. (When memorizing the front passen-
ger’s seat, adjust the front passenger’s seat to the desired
positions.)
Press the “SET” button, then
within 3 seconds press button
“1”, “2” or “3” until the sig-
nal beeps.
If the selected button has
already been preset, the pre-
viously recorded position
To Next Page
Loading...
