172
3-3. Adjusting the seats
LX570_450d_OM_OM60R63E_(GE)
■ To stop the position recall operation part-way through
Perform any of the following:
● Press the “SET” button.
● Press button “1”, “2” or “3”.
● Operate any of the seat adjustment switches (only cancels seat position recall).
● Operate the tilt and telescopic steering control switch (only cancels steering wheel
position recall).
■ Operating the driving position memory after turning the engine switch off
Recorded seat positions can be activated up to 180 seconds after the driver’s door is
opened and another 60 seconds after it is closed again.
■ If the battery is disconnected
The memorized positions must be reset because the computer’s memory is erased when
the battery is disconnected.
Each electronic key (including a card key) can be registered to recall your pre-
ferred driving position.
■ Registering procedure
Record your driving position to button “1”, “2” or “3” before performing the
following:
Carry only the key you want to register, and then close the driver’s door.
If 2 or more keys are in the vehicle, the driving position cannot be recorded
properly.
Check that the shift lever is in P.
Turn the engine switch to IGNITION ON mode.
Recall the driving position that you want to record.
Memory recall function (driver’s side only)
To Next Page
Loading...
