227
4
4-2. Driving procedures
Driving
LX570_450d_OM_OM60R63E_(GE)
Turn signal lever
The turn signal lever can be used to show the following intentions of the driver:
Right turn
Lane change to the right (move the
lever partway and then release it)
The right hand signals will flash 3 times
Lane change to the left (move the
lever partway and release it)
The left hand signals will flash 3 times.
Left turn
■ Turn signals can be operated when
The engine switch is in IGNITION ON mode.
■ If the indicator flashes faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned out.
■ If the turn signals stop flashing before a lane change has been performed
Operate the lever again.
■ To discontinue flashing of the turn signals during a lane change
Operate the lever in the opposite direction.
■ Customization
The number of times the turn signals flash during a lane change can be changed.
(Customizable features P. 638)
Operating instructions
1
2
3
4
To Next Page
Loading...
