7.4.10 Assemble fan
1. Assemble the fan with a 8 mm Allen key.
2. Tighten the cap screw by hand and torque screw to 20 Nm after
locking the fan by spanner.
1. Fan1. Fan
7.4.11 Assemble drive enclosure
1. Put the foam in place on the pump.
2. Assemble the drive enclosure onto the bearing ange with 3 cap
screws with a 5 mm Allen key
.
3. Tighten the cap screws by hand and torque each screw to 2.5 Nm.
1. Foam 2. Drive enclosure1. Foam 2. Drive enclosure
31
300766038_002_C3 - 09/2021 - © Leybold
Maintenance
To Next Page
Loading...
