– Wearing protective gear
– Dressed in highly visible clothing
– Using a RED rear-facing tail light
– Travelling with proper tools and tire repair
– Light is properly mounted (see MOUNTING)
– Light is properly charged (see CHARGING)
Warnings:
– Lezyne LED Lights are meant to be operated in temperatures between -25°C and 45°C (5°F
and 113°F).
– Lezyne LED Lights should only be attached using supplied mounting brackets. DO NOT use
Lezyne LED Lights as handheld flashlights.
– DO NOT look directly into light beam, or shine at another person’s eyes.
– Lezyne LED Lights are water resistant under normal conditions, but are NOT waterproof.
DO NOT SUBMERGE UNDERWATER. If moisture gets inside light body, open the Rear Battery
Door, remove the battery, and air-out until completely dry.
– NEVER ATTEMPT TO REMOVE FRONT LENS OR ELECTRONICS. Doing so will void your
warranty.
If replacing battery, only use Lezyne branded LIR 2 Cell (part # 4712805979608). Make certain (+)
positive terminal and (-) negative terminal are inserted into housing correctly aligned. Never attempt
to use two (2) LIR 28650 batteries in place of one LIR 2 Cell battery. See CHARGING for instructions on
installing the battery.
Lezyne USA Inc. does not accept any liability for injuries or other damages resulting from the use of
this product in any circumstances
Warranty
In the U.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the original purchase date
to the original owner (proof of purchase is required). This warranty covers materials and
manufacturing defects on the LED light housing, electronics, LED, and the mounting bracket supplied.
Lezyne Batteries carry a 6-month warranty against any manufacturing defects. Issues not covered by
the warranty include normal wear and tear, improper installation, attempted access to electronics,
modification of electronics, damage or failure due to accident, misuse, abuse, and/or neglect.
Contact your local dealer or visit www.lezyne.com for complete warranty information and contact
information regarding warranty issues.
For warranty issues outside of the U.S., please contact the Lezyne distributor/retailer for your country
or region directly.
Mounting:
1. Select correct bar clamp for handlebar diameter (25.4mm or 31.8mm; use rubber shims for
handlebar diameter variation).
2. Slide clamp over handlebar with bolt hole facing forward, place top mount on clamp, and insert
thumbscrew from bottom.
3. Tighten thumbscrew until snug; clamp should not rotate on handlebar. DO NOT OVERTIGHTEN.
4. Slide LED light into top plate from front and push until body clicks into place.
5. To remove LED light, press release tab and pull light forward. Take caution as light body may be
warm.
To Next Page
Loading...