63
9. Repeat steps 7-8 until all Upper Punches are removed.
10. Push up the the Lower Punch Insertion Disc underneath the Lower Punches and remove it from
the RTP 9®.
11. Remove the righthand panel door.
12. Rotate the Handle until a Lower Punch is aligned with where the Lower Punch Insertion Disc
was previously.
13. Gently pull on the Lower Punch's head through the hole.
13.1 Note: Be sure to have a firm hold on the Lower Punch so that it does not fall and
become damaged.
14. Repeat steps 12-13 until all Lower Punches are removed.
To Next Page
Loading...