78
Clean the Parts
6. Take one of the parts removed from the machine and bring it to the bowl of soapy water.
6.1 Note: To ensure that all dirt and debris are removed, wash one part at a time.
7. Take a clean cloth and carefully wash the part thoroughly.
7.1 Note: Use the toothbrush for difficult-to-remove debris. When cleaning tooling, use
non-abrasive cleaning equipment such as a soft pipe cleaner and soft cloth.
8. Dry part immediately after it is cleaned and rinsed.
9. Sanitize part with a clean cloth.
10. Lubricate part.
11. Repeat steps 6-10 for each remaining part until they are all clean.
Clean the Base
12. Spray the RTP 9® base with the cleaner, particularly in the Tooling's location.
13. Rinse the cleaner off with potable water.
14. Sanitize the the RTP base with a clean cloth.
Note: Before washing the Turret and Die bores, LFA recommends
using our Die Seat Cleaner. You can order the Die Seat Cleaner
and Insertion Ring on our website at https://www.lfatabletpresses.
com/die-seat-cleaner-insertion-ring
To Next Page
Loading...