11
• When battery indicator next to the outdoor temperature, replace batteries
in your outdoor sensor.
• When battery indicator shows next to your atomic tower icon, replace
batteries in your wall clock.
• In Normal display, press and hold CHANNEL over 3s to search the outdoor
temperature/humidity sensor.
• The wall clock can support up to 3 sensors with different channels 1/2/3.
• The signal strength icon will animate until the sensor(s) signal is received, or
for 5 minutes if no signal available.
In Normal display, press and release ▼ to interchange the temperature unit
between degree Celsius and degree Fahrenheit.
• In Normal display, press and release CHANNEL to interchange the reading
display for the outdoor temperature/humidity sensors.
• There are CH1, CH2 CH3 or cycle display.
• In cycle display mode , the outdoor temperature reading will be switched
every 3s.
If there is malfunction of the clock, press RESET to restart the clock.
9 LOW BATTERY INDICATION
10 SEARCH FOR OUTDOOR SENSOR
12 SWITCH READING DISPLAY FOR THE OUTDOOR
TEMPERATURE/HUMIDITY SENSORS
11 SWITCH TEMPERATURE UNIT
13 RESET
To Next Page
Loading...
