LG-Ericsson iPECS ES-2024G User Manual

C HAPTER 3 | Installing the Switch
Optional Rack-Mounting Equipment
– 31 –
ES-2024G/2024GP
OPTIONAL RACK-MOUNTING EQUIPMENT
If you plan to rack-mount the switch, be sure to have the following
equipment available:
◆ Four mounting screws for each device you plan to install in a rack—
these are not included
◆ A screwdriver (Phillips or flathead, depending on the type of screws
used)
MOUNTING
The switch can be mounted in a standard 19-inch equipment rack or on a
desktop or shelf. Mounting instructions for each type of site follow.
C AUTION : Stacking switches without enough space for airflow can damage
the switch. Attach rubber feet to the bottom of the switch and make sure
there is sufficient space around the installed switch for airflow.
RACK MOUNTING Before rack mounting the switch, pay particular attention to the following
factors:
◆ Temperature: Since the temperature within a rack assembly may be
higher than the ambient room temperature, check that the rack-
environment temperature is within the specified operating temperature
range. (“Physical Characteristics” on page 50.)
◆ Mechanical Loading: Do not place any equipment on top of the rack-
mounted unit.
◆ Circuit Overloading: Be sure that the supply circuit to the rack
assembly is not overloaded.
◆ Grounding: Rack-mounted equipment should be properly grounded.
Particular attention should be given to supply connections other than
direct connections to the mains.

LG-Ericsson iPECS ES-2024G Specifications

General

Ports	24
Uplink Ports	4 x 1G SFP
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
MAC Address Table Size	8K
PoE	No
Operating Humidity	10% to 90% (non-condensing)
Layer	Layer 2
Management	SNMP
Dimensions	440 x 44 mm
Jumbo Frame Support	9K
Power Consumption	20W
Operating Temperature	0°C
Storage Temperature	70 °C
Storage Humidity	5% to 95% (non-condensing)