LG 27EP950 - Screen Protection and Power Settings; Display, USB, and System Configuration

19
ENGLISH
• [USB Selection]: Select the USB upstream cable connection port to use USB hub of the monitor.
• [Screen Saver]: Control the [Screen Saver].
- On: The screen automatically turns off when it is idle for a certain period of time.
» The indicator flashes Amber colour, while the [Screen Saver] is active. If the still image disappears, the
brightness is automatically restored.
- Off: Turn off the [Screen Saver].
• [Screen Shift]: Control the [Screen Shift].
- On: The screen moves by a few pixels in four directions.
- Off: Turn off the [Screen Shift].
• [Volume]: Adjust the volume.
- You can adjust [Mute] / [Unmute] by a
key in the [Volume] menu.
• [Power LED]: When the [Power LED] function is turned on, it operates as follows:
- On mode: Light up
- Sleep Mode (Standby Mode): Blinking
- Off mode: Off
• [Always On Mode]: Control the monitor action when there is no active video input.
- On: prevent the monitor goes to the sleep mode
- Off: monitor goes to the sleep mode
• [Automatic Standby]: If there is no operation on the monitor for a certain period of time, the monitor will
automatically switch to standby mode.
• [DisplayPort Version]: Set DisplayPort Version to the same version as the connected external device. To use the
HDR function, set to [1.4].
• [Hot key Settings]: Select the hot key menu of key in the Main Menu; [Picture Mode], [Peak Brightness],
[PQ Clip Point], [Input Range], and [Information].
• [OSD Lock]: This feature disables the configuration and adjustment of menus.
• [Information]: The following display information will be shown; [Input], [Resolution], [Chroma], [Color
Depth], [Input Range], [Picture Mode], [Color Temp], [Color Gamut], [Gamma(EOTF)], [SW Version], [Total
Power On Time].
• [Reset to Initial Settings]: Returns to the default settings.
NOTE
•
[HDMI ULTRA HD Deep Color]
- To use [HDMI ULTRA HD Deep Color], turn this function on.
- If the connected device does not support Deep Colour, the screen or sound may not work properly. In this
case, set this function to off.