101
206-4271
Channel Preview/Banks Setup Menu
CHANNEL PREVIEW - BANK 1
CH 011-001 NORMAL-ADDED
Enter -> Change
CC -> VCHIP Menu, Ch. Preview -> Exit
Symptom
Possible Cause Possible Solution
Cannot change channel
status in menu.
Channel Access was denied in Express
Script.
Set CH. OVERIDE to 1 to allow access for channel
status change. (Make sure to reset item 028 back to 0
when you are nished with channel banks setup.)
Channel Preview/Banks
Setup Menu does not
appear.
Express Script not completed. The Channel Preview/Banks Setup Menu will not be
available until the TV setup is transferred to the PTC.
Also, set Installer Menu item 028 CH. OVERIDE to 1 to
allow access for channel status changes. (If applicable,
make sure to reset item 028 back to 0 when you are
nished with channel banks setup.)
Channel is blanked in all
channel banks.
Blanking a channel in one channel bank
will make it blank in all channel banks.
Modify the channel status in the Channel Preview/Banks
Setup Menu, if desired.
Cannot tune in deleted
channel on Channel
Preview/Banks Setup Menu.
While its status in the currently selected
bank is NORMAL-DELETED, the channel
is not accessible using Channel Up/Down
arrows on the Installer Remote.
(Re)select the channel bank in which the status of the
channel is NORMAL-DELETED, and direct enter the
deleted channel number. You can then modify the channel
status in the Channel Preview/Banks Setup Menu, as
desired.
“Inactive TV” message
appears and then TV turns
OFF.
TV is set up to display “Inactive TV”
message if all channels are “NORMAL-
DELETED” from Channel Bank 4.
Select another channel bank (1, 2, or 3) to return TV to
normal operation.
Channel found during Auto
Tuning does not tune in with
Channel Up/Down.
Channel was deleted in currently selected
channel bank.
If banks were set up, premium channels may only be
available on another channel bank. Select the channel
bank where the channel is set to NORMAL-ADDED. Or,
direct enter channel number; then go to Channel Preview/
Banks Setup Menu and select “NORMAL-ADDED.”
When BANK on Installer
Remote is pressed, TV
shows Input List Menu.
Installer Menu item 027 HOSPITAL MODE
is set to 0.
Set item 027 to appropriate setting for channel banks to
appear with CH. BANK key presses.
Troubleshooting (Cont.)
Channel Banks Setup Troubleshooting
To Next Page
Loading...
