30
206-4271
Express Script (Cont.)
(Continued from previous page)
CHANNEL OVERRIDE
Do you want to allow access to channels that are not in the channel lineup?
<
YES
>
07
BACK
NEXT
EXIT
7. As the nal step of the Express Script, the TV saves your settings and transfers the auto-tuned/
edited channel lineup to the commercial controller (PTC). When you are ready to proceed, select
FINISH, and then press OK.
EZ-MANAGER CONFIGURATION COMPLETE
Installed Components
Pro:Centric Application GEM application downloaded
Maintenance Files LYH_Config.tlx
TURN OFF
REBOOT
COMPLETE THE EXPRESS SCRIPT
Saving data...
50%
This step transfers the auto-tuned/edited channel lineup to the TV’s commercial controller (PTC). Note that
the maximum number of channels (analog, digital, and Aux inputs) that can be transferred to the PTC is 141; any
extra channels will not be available in the PTC Channel Map. Aux inputs will appear between the highest analog
and lowest digital channel number in the PTC Channel Map.
If you did not run Auto Tuning, no analog or digital channels will be transferred to the PTC Channel Map upon
completion of this step. In this case, the only channels in the PTC Channel Map will be any enabled Aux inputs.
Select FINISH to complete the Express Script.
08
BACK
FINISH
EXIT
Conguration progress will be shown at the bottom of the screen. When this step is complete, the
Express Script exits, and the TV tunes to the rst channel in the PTC Channel Map.
Note: If desired, you can clone the TV Setup created from the Express Script using a legacy
LT2002 or TLL-1100A clone programmer.
Note: If access to the channel lineup has been limited at the completion of the Express Script
(see step 6) and you would like to set up channel banks at a later time, you will need to set
Installer Menu item 028 CH. OVERIDE to 1 to enable access to the Channel Preview/Banks
Setup Menu. See pages 49 to 52 for further information on channel banks.
To Next Page
Loading...
