ASSEMBLINGANDPREPARING15
Mounting on a table
1 Lift and tilt the TV into its upright position on a table.
- Leave a 10 cm (4 inch) (minimum) space from the
wall for proper ventilation.
,.---@ NOTE
* When adjusting the angle of the TV, watch out for
your fingers.
_>Personal injury may occur if hands or fingers are
pinched. If the product is tilted too much, it may fall,
causing damage or injury.
Front Rear
2 Connect the power cord to a wall outlet.
Do not place the TV near or on sources of heat, as
this may result in fire or other damage.
Swivel 15 degrees to the left or right and adjust the
angle of the TV to suit your view.
(For 42/47/50LA6200, 42/47/50LA6205)
Fix the TV to a table to prevent from tilting forward,
damage, and potential injury.
1 Connect the Desk-mount Cables to the Stand Base
using the Bracket Screws.
2 Fix the Desk-mount Cables to a table using the Desk-
mount Screws.
3 Once the TV is fixed, move the table close to the
wall. Children may go in, causing injuries.
×*__) (For47/50LAX__*)
4X8 _P4X8
EA 2 EA
_--_ WARNING
To prevent TV from falling over, the TV should be
securely attached to the floor/wall per installation
instructions. Tipping, shaking, or rocking the TV
may cause injury.
To Next Page
Loading...
