MAGIC REMOTE CONTROL FUNCTIONS 31
Registering Magic Remote Control
The Magic Remote Controt operates by pairing with your
TV.
To register automatica!!y, turn the TV on and ]
Press the @ Wheel(OK}. When registration /
is completed, the completion message
appears on the screen. /
If registrati0n fails, turn the _ off and back
(Wheel) on, then press the @ Whee! (OK)to
complete registration. ]
he _ BACK and ]
<_ I SMART ___..buttons together for 5 seconds
BACK I to reset, then register it by following t_How /
I to register the Magic remote poatr0!il /
,_ I above.
___ 12 To re-register the Magic remote Control,
SMART I press and hold the<_ BACK butto_ foF 5 /
[ seconds tovvard the TV. .l
How to use Magic Remote Control
_ou ¢a_ move the pointerby m0ving the
rem0te Up and down 0r left and r!ght:
? / >> if the pointer d0es not work properly
,?0.._ . . ,
,_¢ .......... I wait 10 seconds and then try again.
2 if the p0inter disappears, move the remote
control slightly to left or right. It wil! then
automatically appea r on the screen.
_> if _he pointer has not been used for a
certain period of time, it will disappear.
Precautions to Take when Using
the Magic Remote Control
Use the Magic remote control within the maximum
communication distance (10 m, 32.8ft). Using the remote
control beyond this distance, or with an object obstructing
it, may cause a communication failure.
A communication failure may occur due to nearby devices.
Electrical devices such as a microwave oven or wireless
LAN product may cause interference, as these use the
same bandwidth (2.4 GHz) as the Magic remote control.
The Magic remote control may be damaged or may
malfunction if it is dropped or receives a heavy impact.
Take care not to bump into nearby furniture or other
people when using the Magic remote control.
Manufacturer and installer cannot provide service related
to human safety as the applicable wireless device has
possibility of electric wave interference.
Jt is recommended that an Access Point (AP) be located
more than 1 m (3.28 ft) away from the TV. If the AP is
installed closer than 1 m (3.28 ft), the Magic remote
control may not perform as expected due to frequency
interference.
To Next Page
Loading...
