32/3 7/42LGSooH
BACKCOVERFORWIRE
ARRANGEMENT
Connect the cables as necessary.
To connect additional equipment, see the
EXTERNAL EQUIPMENT SETUP section.
Secure the power cable with the PROTECTIVE
BRACKET/Screw or PLUG IN TYPE HOLDER
for power code. It will help prevent the power
cable from being removed by accident.
........................® o
PROTECTIVE BRACKET PLUG IN TYPE HOLDER
(This feature is not available for all models.)
Install the CABLE MANAGEMENT CLIP as shown.
If your TV has the CABLE HOLDER, install it as
shown and bundle the cables.
CABLE MANAGEMENT
CABLE HOLDER
O Put the cables inside the CABLE MANAGEMENT
CLIP and snap it closed._
PROTECTION COVER
After removing the stand, install the included protection
cover over the hole for the stand.
Press the PROTECTION COVER into the TV until you
hear it click.
STAND INSTALLATION
Carefully place the TV screen side down on a cush-
ioned surface to protect the screen from damage.
//
Assemble the parts of the STAND BODY
with COVER BASE of the TV.
BODY
BASE
Assemble the TV as shown.
4
or
f _ _ Tighten the two of these four screws
/-_ xZ x2 andthetwoTorxplusstarheadscrews
J
| (provided as parts of the TV) to securethe TV. Tighten
| the two Torxplus star head screwswith a star headdri-
L,ver bit (not provided as parts of the TV).
-0
_o
m
_o
0
z
15
To Next Page
Loading...
