LG 42LC5DC - - 42" LCD TV - Programming the Remote Control

PROGRAMMING THE REMOTECONTROL
The provided universal remote control can be programmed to operate most remote-controllable devices.
Note that the remote may not control all models of other brands.
Programming a code into a remote mode
To find out whether your remote control can operate each device without programming, turn on the device
(such as a VCR) and press the corresponding mode button on the remote.
After that, press the POWER button. If the device is turned off and it responds properly the remote control
need not be programmed. If not, the remote should be programmed to operate the device. The program-
ming procedures are explained below.
Press the MENU and MUTE button continuously at the same time for two seconds; the currently selected
device button is illuminated.
If you don't press any button for 20 seconds, the light on the mode button will be turned off. In that case,
you have to repeat from step 2.
Enter the appropriate code from the code table on the following pages. When pressing the button, the
light blinks at a time. If the device turned off, the programming is successful.
Press the MENU button to store the code. After blinking twice, this code is stored.
Test the remote control functions to see if the device responds properly. If not, steps 2-5.
-O
-O
m
z
x
Remote
DVD
Control Code
022 Mi _i i 002 005 006
i_!_i_i_J_i__i_i_!_!_i_!_!_!_!_i_i_!_!_i__i_i_,_i'i_!_i_!_i_'_i_i
DENON 020 014- .............................. 023 ........ 011 015
oosoo6 oo8olz ooz
o27 PA_8_i_ oo3
009 THOMPSON 005 006
o12 o13 _i_ o19oo8
i i!!iii i ii_i_i ii iiii iiiiiiiiiiiiiii
LG 001 010 016 02S PIONEER 004- 026 YAMAHA 009 018
013 021 Ni 010 016 02S
.....MARANTZ 024 PROSCAN OOS 006
84