16 Plasma TV
- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
- This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
How to connect
Use the TV’s COMPONENT (Y, P
B, PR) INPUT, RGB or
HDMI1/DVI jack for video connections, depending on your
set-top box connector. Then, make the corresponding
audio connections.
How to use
1. Turn on the digital set-top box. (Refer to the owner’s
manual for the digital set-top box.)
2. Use INPUT on the remote control to select Component ,
RGB-DTV, or HDMI1/DVI source.
HDSTB Setup
HDSTB Setup
Digital Set-top Box
Signal
480i
480p
720p
1080i
Component
Yes
Yes
Yes
Yes
RGB1/2-DTV , HDMI1/DVI
No
Yes
Yes
Yes
or
1. Connect the DVI output of the digital set-top box to the
HDMI1/DVI IN or HDMI IN 2 jack on the set.
2. Connect the audio output of the digital set-top box to the
AUDIO IN(RGB/DVI) jack on the set.
3. Turn on the digital set-top box. (Refer to the owner’s
manual for the digital set-top box.)
4. Select HDMI1/DVI or HDMI2 input source with using the
INPUT button on the remote control.
• If the digital set-top box has a DVI output and no
HDMI output, a separated audio connection is nec-
essary.
• If the digital set-top box supports Auto DVI function,
the output resolution of the digital set-top box will be
automatically set to 1280x720p.
• If the digital set-top box does not support Auto DVI,
you need to set the output resolution appropriately.
To get the best picture quality, adjust the output res-
olution of the digital set-top box to 1280x720p.
To Next Page
Loading...
