- 20 -
LGE Internal Use OnlyCopyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
7. Soft Touch Key Check
- Before you start a test, you must run a ‘Power Only Mode’.
AFTER Touch SOFT TOUCH KEY OF SET, LOCAL KEY
CHECK DISPLAY WILL START
(1) Tab Test : Touch SOFT TOUCH KEY OF SET quickly
(2) Left Test : Touch SOFT TOUCH KEY OF SET to the left
side.
(3) Right Test : Touch SOFT TOUCH KEY OF SET to the right
side
(4) Long Tab Test : Touch SOFT TOUCH KEY OF SET long.
- Don’t need to run a test with this sequence. For example, the
sequence such as ‘Right → Tab → Long Tab → Left’ is
allowed.
8. EYE Q Green Inspection
(1) Turn on TV
(2) Press EYE key of Adj. R/C
(3) Cover the Eye Q sensor on the front of the using your hand
and wait for 6 seconds
(4) Confirm that value is lower than 100 of the “Raw Data
(Sensor data, Back light )” If after 6 seconds, value is not
lower than 100, replace Eye Q sensor
(5) Remove your hand from the Eye Q sensor and wait for 6
seconds
(6) Confirm that “ok” pop up. If change is not seen, replace
Eye Q sensor
To Next Page
Loading...
