31
ASSEMBLING AND PREPARING
4
Stand cover
Insert the protruding parts of the
Stand cover into the holes.
CAUTION
5
Cover holder
Stand cover
Insert the Cover holder of the Stand
cover into the holes until it clicks.
CAUTION
Remove the stand before installing
the TV on a wall mount by
performing the stand attachment
in reverse.
NOTE
When attaching the stand to the
TV set, place the screen facing
down on a cushioned table or flat
surface to protect the screen from
scratches.
Make sure that the screws are
inserted correctly and fastened
securely. (If they are not fastened
securely enough, the TV may tilt
forward after being installed.)
Do not use too much force and
over tighten the screws; otherwise
screw may be damaged and not
tighten correctly.
CAUTION
To Next Page
Loading...
