LG 55EJ5E - Page 104

ENGLISH
66
42. Fail Over Select (Command: m i)
Sets an input mode for fail over.
Transmission
[m][i][ ][Set ID][ ][Data][Cr]
Data 00: Off
01: Auto
02: Custom
Acknowledgment
[i][ ][Set ID][ ][OK/NG][Data][x]
43. Fail Over Input Select (Command: m j)
Selects an input source for fail over.
* This feature is only available when Fail Over is set to Custom.
Transmission
[m][j][ ][Set ID][ ][Data1][ ][Data2][ ][Data3][ ][Data4]
… [ ][DataN][Cr]
Data 1 to N (input priority 1 to N)
60: RGB
70: DVI-D
90: HDMI1
91: HDMI2
92: OPS/HDMI3/DVI-D
95: OPS/DVI-D
96: HDMI3/DVI-D
97: HDMI3/HDMI2/DVI-D
98: OPS
C0: DISPLAYPORT
Acknowledgment
[j][ ][SetID][ ][OK/NG][Data1][Data2][Data3][Data4]
…[DataN] [x]
* Some input signals may not be available with certain models.
* The data number (N) may vary depending on the model. (The
data number depends on the number of supported input
signals.)
* This feature operates as the last input, and supports data in
DTV format.
44. Remote Controller Key Lock (Command: t p)
Configures the settings of the product's remote control key.
Transmission
[t][p][ ][Set ID][ ][Data][Cr]
Data 00: All keys lock off
01: Locks on all keys except Power key
02: Locks on all keys
Acknowledgment
[p][ ][Set ID][ ][OK/NG][Data][x]
* When the monitor is turned off, the power key works even in
the locks on all of the keys (02) mode.
45. Local Key Lock (Command: t o)
Configures the local key operation settings of the product.
Transmission
[t][o][ ][Set ID][ ][Data][Cr]
Data 00: All keys lock off
01: Locks on all keys except Power key
02: Locks on all keys
Acknowledgment
[o][ ][Set ID][ ][OK/NG][Data][x]
* When the monitor is turned off, the power key works even in
the locks on all of the keys (02) mode.
* This feature may not be supported on some models.