LG 55EW960H - Page 57

57
206-4307
IP Environment Setup (Cont.)
Conguring a Wired Network Connection
Note: If desired, you can congure both wired and wireless
connections. However, note that a wired connection is always
prioritized over a wireless connection. That is, when the TV is
turned OFF and then back ON, if a LAN cable is detected between
the TV and the network, the TV will default to the wired connection.
If the LAN cable is removed, the TV will then attempt to establish
the wireless connection. Whenever the LAN cable is reconnected,
the TV will re-establish the wired connection.
1. Connect the appropriate cable between the TV and the network.
2. With the Network Menu on display, use the arrow keys on the
Installer Remote to select Network Setting. Then, press the
Wheel (OK) button. A second Network screen (see example at
right), with Wired and Wi-Fi Connection setup options, will be
displayed.
By default, the TV uses DHCP, and if a LAN cable is detected,
the TV will attempt to connect to the network as soon as you
select “Network Setting” above. If the TV is able to connect to
the network, a “Connected to Internet” message will be displayed
below the Wired Connection eld.
3. If the network is not congured for DHCP or you want to specify
static conguration data or you would like to change the network
conguration from Manual to Automatic, edit the IP conguration
for this TV as follows:
• In the second Network screen, select Wired Connection and
press the Wheel (OK) button. Then, in the Wired screen, select
Edit (if not already selected) and press the Wheel (OK) button.
• In the Edit IP screen, select or de-select the “Set Automatically”
checkbox, as required. A checkmark indicates that Automatic
conguration is enabled.
• To manually edit the IP conguration, for each data entry eld:
Use the arrow keys on the Installer Remote to select the eld
and press the Wheel (OK) button. You can use the number
keys on the Installer Remote to direct enter numeric values or
use the arrow keys to select the appropriate numbers from the
pop-up virtual keyboard displayed at the bottom of the screen.
(Note, however, that you must use the dot “.” key from the
virtual keyboard to separate each octet of an IP address.) When
you are done, select Enter from the virtual keyboard, and then
press the Wheel (OK) button on the Installer Remote.
• When all Edit IP elds are set as required, use the arrow keys
on the Installer Remote to select Connect and press the
Wheel (OK) button.
At the top of the screen, you will see a progress display that
indicates status as each network element is conrmed (see
example at right).
NETWORK SETT...
Network /
Wired Connection (Ethernet)
Not Connected
Wi-Fi Connection
Not Connected
Network
Pro:Centric
Media Share
Pre-loaded
Apps
EDIT IP
Network / Network Setting / Wired Connection (...
Connected to Internet
Set Automatically
IP Address
Subnet Mask
Gateway
DNS Server
CONNECT
Network
Pro:Centric
Media Share
Pre-loaded
Apps
WIRED
Network / Network Setting /
Connected to Internet
IP (Automatic)
IP Address 10.1.2.4
Subnet Mask 255.255.255.0
Gateway 10.1.2.3
DNS Server 10.1.2.3
MAC Address C8:08:E9:40:49:F5
EDIT
Network
Pro:Centric
Media Share
Pre-loaded
Apps
DNS
(Continued on next page)
10.1.2.4
DNS
10.1.2.3
10.1.2.3
255.255.255.0