LG 55LW5600 - Understanding the Host Diagnostic Screen

Wireless Host Ver:0.00.0
Wireless B/B Ver:0.00.0
RF Region Config : Not Configured
Media Box Type : Not Configured
RF Frequency (Value):Auto (N.A.)
Uplink RF Power gain (Value):Auto (Min 0)
Downlink RF Power gain (Value):Auto:Auto (Min 0)
Link Mode : Unicast
RX MAC Address : ff:ff:ff:ff:ff:ff
TX MAC Address : ff:ff:ff:ff:ff:ff
Wireless connection status : Disconnected
Average SNR [Db] : 0.0 (0)
Host Information
Memory
Host Release Version
FAT Status (Main)
Current Channel (Main)
Channel Info : Digital 19-1
Parental Control : Channel is not blocked
Host Diagnostics
Model Name : 55LW5600-UA (Liquid Crystal Display)
FLASH : 524288 KB
DRAM : 524288 KB
NVM : 128 KB
Firmware Version(PQ) : 2.02.07.01(25329)
Micom Version : V2.21.2
Compile Date & Time : 20101130 & 08:45:52
Compile User : hellyhorse.kang
Center Frequency : 663.00 MHz
PCR lock : Locked
Modulation mode : QAM 256
Carrier lock status : Locked
SNR : 37 dB
Signal level : 100%
Half Page Move Page Exit
CH
23
55LW5600 Understanding the Host Diagnostic Screen (Page 2 of 2)
DVI/HDMI Status
Can’t display this information now
Wireless ready Status
Channel
Selected
Blocked or
Not Blocked
Software
Version
Channel Frequency
Program Clock Reference (Locked or No)
Channel Type (8VSB, QAM 64, 256)
Channel (Locked or Unlocked)
8VSB (Above 20 is good)
QAM 64 (Above 24 is good)
QAM 256 (Above 30 is good)
Channel Signal to Noise Ratio
Channel Signal Level (Above 80% good)
July 2011 LCD-DV 47LW5600